CCPN LogoVideo
Tutorials
& Manual
CCPN Logo

AnalysisScreen Hit Analysis Filtering

AnalysisScreen Hit Analysis Filtering

In the Hit Analysis module Settings there is a Filters tab which allows you to apply a large number of filtering options to your tables. Applying these will allow you to target specific areas of interest in your screening dataset, simplify the tables and also speed up the program.

The Filters panel has three main sections, corresponding to the Peak Binding Scores, Substances and Samples tables (see our Hit Analysis Tables page for more information on these tables). Filters will only be applied when Matches, Substances or Samples are ticked. Use the >, >=, <, <=, == (equal) and != (not equal) signs to filter on a range of values, including Binding, Displacement and Matching Scores, Signal/Noise Ratio or Flags. You can also set a column by which to sort your table (by default this is descending, unless you tick the Ascending Sort box). At the top of the panel you can restrict the table to show only the top X number of results.

To apply the filtering, you need to press the Filtering button (next to the Update button) in the main part of the Hit Analysis module. If you make any changes to the Filters, the Update button will go orange you will need to press it to re-apply the new Filters (the Update button will then go green again).